Please re-test the drive with Data Lifeguard. Browse other questions tagged hard-drive hardware-failure smart or ask your own question. Please ensure that you are not loading any other DOS level files from the floppy prior to running diagnostic utility. Replace Drive 207 SMART status failed before the media scan. Source
Replace Drive 215 2-9 IDNF Errors Identified Data Not Found (IDNF) 2-9. There were media errors that were within the repair capabilities of diagnostic utility. Does Voldemort have any hobbies? share|improve this answer answered Apr 17 at 20:48 Hector Julio Duran 1 add a comment| Your Answer draft saved draft discarded Sign up or log in Sign up using Google
Re-test and Repair Option diagnostic utility 212 10+ Uncorr ECC Errors Error Correction Code (ECC) 10+. Re-test Drive with appropriate diagnostic utility 133 Illegal ID FW overlay not found. Error 14 occurred at disk power-on lifetime: 22 hours (0 days + 22 hours) When the command that caused the error occurred, the device was active or idle.
In other words, all of us, all of the time, are using partially defective disks. There were too many errors found on this drive to be repaired. Replace Drive 223 Errors Repaired Errors found, but have been repaired successfully. An onboard defect counter has determined the drive has too many errors and should be replaced.
The drive is defect free. Western Digital Error Code 0007 Check your floppy and retest. Replace. Retest after checking the connections.
Please re-test the drive with Data Lifeguard. Check Floppy and use appropriate diagnostic utility 207 Critical Resource Error Unable to locate and/or use a system resource (e.g. - printer). Replace drive if unable to correct error 118 DAM Error Data Address Mark (DAM) Error. Replace Drive 585 Busy Timeout During a read verify, a command could not be completed.
The drive has not responded to the SMART test request. Replace the drive if the error repeats. Wd Error Codes Re-test 132 Command Error Command Aborted. Data Lifeguard Diagnostic For Dos Re-Test Drive 210 Self Test Failed The drive's internal self-test reported unrepairable errors.
Check cable & retest. Replace Drive If an error code is encountered that is not in the list above, please Contact Us for additional troubleshooting. This may be due to a media or read error. This error can occur on non-Western Digital drives. Western Digital Support
Re-Test Drive 112 IRQ Timeout Interrupt ReQuest Interrupt signal not received. If the automatic repair feature is unable to repair these errors, replace the drive. Re-Test Drive 104 Drive Not Ready The drive did not properly respond to test commands. This may be due to a media or read/write error.
Replace Drive 214 10+ DAM Errors Data Address Mark (DAM) 10+. Replace Drive 225 Too Many Errors Found Error count reached a threshold value. Replace Drive 13 Failed to Repair Sector A test failed to repair bad sectors. Return to Top In case the answer did not answer your question, you can always visit the WD Community for help from WD users.
Replace the drive if the error repeats. This error may also be related to memory issues.